i own a 71 moto guzzi that I've been painstakingly rebuilding, well i sent the gas tank out to be pressure tested and sealed prior to doing anything on the bike, i got it back and you could see the coating, well after several years and getting the bike painted we got her back together and on our maiden voyage we discovered a leak in the tank well what can i do it's been several years sense i had it painted well a friend told me of your product i purchased it and after following the directions to the t i can't be any happier i would and do recommend this product to anybody that has a leak.

your truly a very happy gonzo

I had pinholes in an old motorcycle gas tank. This was a great product, less expensive than Kream and worked as advertised. It was easy to apply and am happy with the results.

I could not be more pleased with your product. I read up about tank sealers online and the large majority of post I read recommended KBS. The instructions were easy to follow and if you take your time you will have a tank that's good as new.

I own an independent Harley Davidson motorcycle repair shop. I have used KBS coatings for a long time and have found your products to be way above the rest.

At the present time I am working on a 1953 Indian Chief restoration. Someone previously used and inferior product to seal the tank. Needless to say it is peeling off inside. I have full confidence the KBS stripper will remove all the old sealer, so I can properly re-seal this tank with the 3 step process. Thus allowing this old Indian Chief to roar to life once again.

I wouldn't trust anything else but KBS for this valuable antique.

Just thought I'd share. I can't say enough good things about this stuff. If you need to paint a rusty frame or underbody or tank, this is what you want. I have used it several times with ZERO failures.

I have tried the POR stuff and it's good but not like this. The POR has a good high temp engine paint but for rust converter, KBS!

Click here for the entire thread: http://www.v8s10.org/forum/viewtopic.php?f=26&t=23975