Q: Will this kit work on a diesel tank?
A: Yes, the KBS 3 Step Tank Sealing steps is used on Diesel Tanks all of the time. The Gold Standard Tank Sealer is completely impervious to diesel fuel.
Q: Will this Tank Sealer Kit work on a small water tank used for a steam engine?
A: Yes, the Auto Fuel Tank Sealer Kit will work on a tank 25 gallons or less that holds water used for a steam engine.
Q: I have a pickup with a 60 gallon steel auxiliary fuel tank for gasoline. Do you offer a kit for something of this size? Any help would be greatly appreciated.
Q: Can I use this on a Bio-Diesel fuel tank?
A: Yes, the Tank Sealer is impervious to bio-diesel fuel.
Q: Will this product work on a fiberglass tank?
Yes, the Auto Fuel Tank Sealer Kit will work on fiberglass tanks. Be sure to check out the section on fiberglass tanks in our Tank Sealer directions found HERE
Q: Is the coating thin enough to be able to coat a gas tank with baffles in it just by rotating the tank through different orientations? The tank has been removed from the car and the tank has been coated with Ospho to transforn the rust to an Iron phosphate surface.
A: Yes, you can coat a tank with baffles. The Tank Sealer was designed to flow through the tank covering the entire tank including baffles by rotating the tank slowly in all directions. Be sure to use the KBS Klean and RustBlast first to prep the inside of your tank.
Q: I have an old car gas tank that I brazed acouple little holes shut and I want to use your sealer to coat the inside. will this product coat over the little bit of braze ok?
A: Yes, you can absolutely use this Kit (KBS Klean, RustBlast, and Tank Sealer) to seal the inside of a tank that has been brazed.
Q: I have a new reproduction gas tank for my 1952 dodge. will I need to clean or degrease the inside before using your product to seal and prevent rust?
A: Yes. New steel always needs to be cleaned with KBS Klean and etched with RustBlast before applying the KBS Tank Sealer.
Q: Does this kit work with Aluminum Tanks?
A: Yes, the Auto Fuel Tank Sealer Kit works flawlessly on aluminum tanks. Because aluminum can be very smooth, please be sure to etch all of the sides of your tank with the RustBlast for a minimum of 30-45 minutes on each side.
Q: my tank already has a coating ,
will your sealer work ??
Yes. Before you do the KBS 3-Step Tank Sealing SYstem, you will want to remove the previous coating using the KBS Strip
. The directions for stripping your tank can be found HERE
Q: I have a 1952 mg td car, the gas tank seams don't look like they are welded, will the rust blast damage the seams?
A: The RustBlast will clean weld seams but should not damage the seams.